Bathtub blister machine refers to the use of vacuum suction and heating to plasticize PVC, PE, PP, PET, buttocks and other thermoplastic coils into the forming machine. The bathtub blister machine is based on a thermoplastic sheet or board, heated to a softening temperature in an oven, and then the vacuum negative pressure between the plastic sheet (sheet) and the plastic molding mold is used to produce plastic in a thermoplastic state. The sheet (plate) adsorbed on the molding surface of the plastic molding mold, and then cooled. These thermoplastic sheets (sheets) usually have materials of PVC, PE, ABS, PS, PP, PET, PETG, APET, ALIEN, and the thickness of the material should be in the range of 200-1200 lines (12mm).
Lianyungang Zeye Machinery Equipment specializes in the production and manufacture of bathtub blister machines and other mechanical equipment. It is a professional blister machine manufacturer with rich experience and product quality assurance. Welcome your call to visit the factory!
Technical requirements for bathtub blister machine:
1. Splint size: 6000×2540×(1-6)mm
2.The lifting stroke of the lifting frame of the forming station: 1400mm
3. Heating method: multiple small quartz heating plates are heated in zones, and each heating plate is controlled by a control heating percentage, which is controlled by a computer programmable controller. SCR electronic power control.
4. It adopts stainless steel inner cavity and color steel shell. 150mm insulation layer (90kg/cubic meter).
5. The time required for normal temperature to rise to 200 degrees Celsius is less than 30 minutes.
6. The temperature difference of the baking sheet: ±20 degrees Celsius.
7. Each cylinder can independently set parameters, modify, save, and call at any time.
8. Splint strength: The clamping force of each quick clamp is 150kg, and it can be equipped with pneumatic splints. Equipped with 4 quick clamps per meter, and set up insurance to ensure that there is no skateboarding.
9. The splint sports car adopts slow start, fast running in the middle, and slow stop when it arrives to ensure fast and accurate positioning.
10. Lifting table stroke: 1000mm (adjustable). Molding height is 1200-1550 mm.
11. The strength of the lifting platform: >4t at the low point, >10t at the top position
12. The height deviation during the lifting process of the lifting platform: ±3mm
13. Lifting speed of the lifting platform: rising <10s, falling="">10s,><>
14. The suction plate strength/air pressure/air volume: strength>150kg/vacuum pipe <>
15. The height of the board from the ground is: 1150mm
16. Cylinder forming vacuum double-channel two-inch double solenoid valve, the suction plate of the suction cup holder is manually operated, the suction cup holder is electric for lifting, and the left and right movement of the suction cup holder is electric.
17. All the above actions can be run manually and automatically.